SCO-815, 5908312596684
Universal lighting dimmer allows you to adjust the brightness of light following light sources:
- Incandescent lamps, halogen lamps, the main series (resistive load R)
- Lamp powered by a toroidal transformer (inductive load L)
- Lamp powered by an electronic transformer (capacitive load C)
- Compact fluorescent lamps (ESL) with dimming
- Energy-efficient LED lights (LED) with dimming
Functioning
Lighting can be controlled by a number of buttons connected in parallel, located at different points in the room. Activation of the receiver at the last set brightness level occurs after a pulse of current caused by pressing any momentary (bell) button connected to the relay. Short press of a button turns on the lighting. Pressing and holding (above 1 second) changes the brightness level in one direction (brightening or dimming). Each time the button is pressed (more than 1 second), the adjustment is made in the opposite direction.
Attention!
Control input is galvanically isolated from the power supply of dimmer. Ability to connect a separate control voltage different from the power supply. Terminals 7-8-9 are connected and form a single point of N.
SCO-815 can be used with backlighted buttons.
Availability date:
Power supply voltage | 230 V AC |
Installation | 3-wires |
The executive element | transistor |
State memory | YES |
Status memory after power failure | NO |
Maximum power of connected bulbs | R/L/C - 500W ; ESL/LED - 100W |
Control voltage | 8÷230V AC/DC |
Application | incandescent lighting, halogen lighting, LED (dimmable), fluorescent lamps (dimmable) |
Control the load | switching on or off at 0 (universal loads) |
Terminal | pluggable terminal blocks 2,5 mm² |
Tightening torque | 0,4 Nm |
Power consumption | 0,1 W |
Working temperature | -25 ÷ 50 °C |
Dimensions | 1 module (18 mm) |
Assembly | on rail 35 mm |
Ingress Protection Marking | IP20 |